Preparing The Remote Control Unit; Installing The Batteries; Remote Control Operation Range - Sharp PN-HW861 Operation Manual

Preparing the Remote Control Unit

Installing the batteries

1. Place your finger on the part marked with the ▲, and then pull the cover off.
2. See the instructions in the compartment and put in the supplied batteries (R03 ("AAA" size) x 2) with their plus (+)
and minus (-) sides oriented correctly.
3. Close the cover.
TIPS
• When the batteries become exhausted, replace them with new (commercially available) batteries.
• The supplied batteries may become exhausted quickly depending on how they are stored.
• If you will not be using the remote control for a long time, remove the batteries.
• Use manganese or alkaline batteries only.

Remote control operation range

Remote control sensor out
Point the remote control unit toward the remote control sensor.
For the monitor in landscape orientation
[PN-HW861]
16.4 feet (5m)
10º
10º
Remote control
16.4 feet
sensor
(5m)
10º10º
For the monitor in portrait orientation
16.4 feet
(5m)
10º 10º
16.4 feet(5m)
10º
10º
Remote control
sensor
17
E