Table of Contents
Advertisement
Chapter 1 - Introduction
1. System Requirements
To begin using the SpaceLink Home Gateway , you must have the following
minimum requirements:
• ADSL/Cable Modem and Broadband Internet Account
• An Ethernet (10Base-T or 10/100Base-TX) adapter for wired client
• At least one 802.11b wireless adapter for a wireless mobile client
• TCP/IP and Internet browser installed
• Printer, which supports standard parallel protocol (SPP) (optional)
The SpaceLink Home Gateway only supports 10Base-T on the WAN
port but supports both 10Base-T or 100Base-TX on the LAN port.
2. LED Indicators
The LEDs on the front of the SpaceLink Home Gateway display the status
of the SpaceLink Home Gateway .
PWR (Power)
Off
(1) No power, (2) During boot sequence
On
(1) Power ON and system ready
Flashing
(1) During boot sequence, (2) Self-test error
AIR (Wireless)
Off
(1) No power, (2) No wireless connection
On
(1) At least one wireless client is associated
Flashing
(1) Wireless traffic through this port is detected, (2) Self-test error
WAN (Wide Area Network)
Off
(1) No power, (2) No wired connection
On
(1) Link to another network device but no traffic
Flashing
(1) Wired traffic through this port is detected, (2) Self-test error
LAN (Local Area Network)
Off
(1) No power, (2) No wired connection
On
(1) Link to another network device but no traffic
Flashing
(1) Wired traffic through this port is detected, (2) Self-test error
LPT (Printer)
Off
(1) No power, (2) No printer is connected
On
(1) The connected printer is switched on
Flashing
(1) Send data to a printer
4
SpaceLink Home Gateway
Advertisement
Table of Contents
