Mounting And Bolt Configurations; Mounting Hardware - Motorola MOTOwi4 25600 Hardware Installation

Ground Based Access Point (GAP) Hardware Installation
Mounting and bolt congurations
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
This section describes different mounting bolt configurations and isolation considerations for
both indoor and outdoor GAP installations.

Mounting hardware

Hilti Bolt
The Hilti bolt is a concrete anchor and bolt. This is shown below in
Isolation washer
The GAP cabinet(s) or rack floor mounting is typically isolated using nylon isolation washers,
and isolation pads bonded to the GAP floor mounting brackets. The islolation washer is shown
as optional parts in
combination washer and bushing.
particularly for ease of installation, vibration supression, and particularly for maintaining
electrical ground isolation.
It may be necessary to ensure grounding isolation on an indoor GAP configuration using a rack.
The rack floor mounting hardware may need to be modified slighly (hole mounting diameter)
for the inclusion of the isolation washer. Additional isolation pads for the rack floor mounting
tabs may also be necessary.
68P09286A73-1
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Every effort should be made to provide a safe working environment for all installation
and service personnel.
The pallets containing the GAP equipment are heavy and require the use of an
industrial fork-lift truck. For the outdoor GAP, the fork lift truck should be rated to
handle at least two tons (2000 lbs or 1000 kg).
Figure 4-1 and
PRELIMINARY - UNDER DEVELOPMENT
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Figure 4-2. The isolation washer depicted in the figures is
Motorola
recommends that the isolation washer be used,
Mounting and bolt congurations
■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■ ■
Figure 4-1
■ ■ ■ ■ ■ ■ ■
■
■
4-5
JUL 2007