Assembling The Battery Release Lever; Attaching The Positive Terminal To The Chassis - Kenwood TK-2317 Service Manual

TK-2317

6. Assembling the Battery Release Lever

1. Place the lever b onto the stopper a .
2. Place the thick spring c onto the lever.
3. Hook the right and left ends of the thin spring d onto the
tabs of the stopper, then place the thin spring onto the
lever e .
4. Slide the shaft through the hole of the stopper and lever f .
7. Attaching the Positive Terminal to the
Chassis
Always attach the positive terminal to the chassis, using
the following procedures, before mounting the TX-RX unit
onto the chassis.
1. Remove the holder assembly b from the packing a of
the positive terminal.
2. Mount the packing of the positive terminal into the chas-
sis hole c .
3. Mount the holder assembly into the packing of the posi-
tive terminal d .
18
DISASSEMBLY FOR REPAIR / 维修拆卸
d
e
a
b
a
6. 电池分离拨杆的组装方法
1. 请把拨杆 b 置于止动器 a 的上面。
2. 请把粗弹簧 c 置于拨杆的上面。
3. 请把细弹簧置于拨杆上面，并让细弹簧 d 的左右端置于
止动器的两个卡头内。 e
4. 滑动轴穿过止动器和拨杆的孔。 f
c
b
7. 把正极端子安装到机架
把收发单元组装到机架之前，必须按照以下的顺序把电池
正极端子安装到机架。
1. 从正极端子的垫片 a 上取下机架 b 。
2. 把正极端子的垫片安装到机架孔上。 c
3. 把支架安装到正极端子的垫片上。 d
c
d
f