Preparing the Camcorder
Preparing the Camcorder
This section outlines the basic preparations for the camcorder, such as attaching the microphone holder and
lens hood and adjusting the LCD screen and viewfinder.
28
Attaching the Microphone Holder Unit
Use the supplied screws to attach the microphone holder unit to the
handle.
Attaching the Lens Hood
Attach the lens hood to protect the lens and reduce the amount of
stray light that may hit the lens. Additionally, keeping the lens barrier
closed can help avoid fingerprints and dirt on the lens.
Always remove the lens hood and attach the lens cap when
carrying the camcorder or storing it after use.
1 Remove the lens cap.
• The lens cap and lens hood cannot be used at the same time.
2 Place the lens hood on the front of the lens with the lock
screw side pointing down
clockwise
( )
.
• Be careful not to deform the lens hood.
• Make sure that the lens hood is aligned with the thread.
3 Tighten the lock screw
Using the Viewfinder
The camcorder's viewfinder features an OLED screen that turns on automatically when you look through the
viewfinder and turns off shortly after you move your eye away from it.
Adjusting the Viewfinder
1 Adjust the viewfinder's angle as necessary.
2 Turn on the camcorder and adjust the dioptric
adjustment lever until the viewfinder's image is
sharp.
NOTES
• You can turn on the viewfinder permanently by
> [¢ " Monitoring Setup] >
setting
[VF Eye Sensor] to [Off].
and turn it 90 degrees
( )
.
( )
Dioptric
adjustment lever