Advertisement
https://www.supplychimp.com
ENTERING THE WRONG CODE
If you press a wrong key while entering your code,
you may press "clear" to reset prior to pressing,
"lock". If you have entered the wrong code followed
by "lock", the LED panel will display "E-COdE"
SECURE LOCKOUT PERIOD
If a wrong code is entered 3 times in a row, the digital
keypad will begin a five-minute lockout period.
During this period the LED will display "HOLD05" and
the keypad will become disabled. Once the lockout
period has expired, the safe can be unlocked using
the active code.
You may use the override key to open safe, but keypad will complete the full lockout
period.
OVERRIDE ACCESS KEY
If the active code is unavailable or your keypad fails due to dead batteries, etc., you
may open the safe using the Override access key.
REPLACING BATTERIES
You may check the battery power at any time by pressing the "lock" key just once.
The LED display will show one of the following messages:
To replace the batteries please follow the instructions in STEP 2. in the SETUP section. It
is NOT RECOMMENDED to use Non-alkaline or rechargeable batteries. Remember to
always remove batteries from safe if not using for an extended period of time.
NOTE: The active code will not be erased if the batteries become weak or are removed.
IF YOU FORGET PASSCODE
1. Insert Override key and turn to right (open position).
2. With the key in the open position press "clear" on your keypad.
3. Turn the key to left (lock) position and remove it from lock.
4. The safe may be opened by pressing any 3-6 digit code followed by "lock".
5. You may now enter any new 3-6 digit code and return to normal operation.
Battery power is good
Battery power is low and batteries should be replaced.
Weak or dead batteries should be replaced
immediately and all 4 batteries should be changed.
3
Advertisement
