Advertisement
https://www.supplychimp.com
SETUP & OPERATION
STEP 1. INSTALL BATTERIES
1. Use the Override Key to Unlock & Open the safe door.
2. Remove battery compartment (A) cover on inside door.
3. Insert 4 "AA" batteries (included).
Ensure the batteries are installed in the correct direction, with
regard to polarity (+ and -) See diagram.
4. Replace the battery cover.
5. Do not close door before testing digital lock.
STEP 2. TEST DIGITAL LOCK
LOCK SAFE
1. Enter the factory preset pass code: "1"-"5"–"9"
2. Immediately after entering the code, press the "lock" key.
3. Lock bolts should extend into the locked position.
UNLOCK SAFE
1. Enter the factory preset pass code: "1"-"5"–"9"
2. Immediately after entering the code, press the "lock" key.
3. Lock bolts should recede into the unlocked position.
STEP 3. LOCK SAFE WITH A NEW PASS CODE
1. Close the safe door and hold it closed.
2. Enter a new (3-6 digit) pass code followed by "lock".
3. Motorized lock will return door to closed position.
4. The LED will display "CLOSED" for 3 seconds followed by
the active code entered as a reminder.
NOTE: The lock design allows for a new user code each time that the safe is locked
STEP 4. OPEN SAFE WITH NEW PASS CODE
1. To open safe enter the new pass code that was used to
lock the safe followed by "lock".
2. The motorized lock will unlock the door and the LED will
display "OPENED".
PRIVACY MODE:
To prevent the LED displaying the pass code entered, press "clear" prior to entering a code.
LOCK SOUND:
To turn "beep" sound On or Off, press the "CLEAR" button twice.
OPEN SAFE WITH OVERRIDE KEY
1. Remove override key cover with small screwdriver.
2. Insert override key and turn left to unlock safe.
3. Pull door open using key as handle.
2
Advertisement
