Apexpro Channelized Telemetry System Configuration; Process Overview; Access The Ats; Configure The Ats - GE ApexPro Service Manual

Configuration
ApexPro Channelized Telemetry System
configuration

Process overview

Access the ATS

Configure the ATS

5-2
After completing the physical installation of the equipment, perform the following
procedures:
1. Access the ATS on page
2. Configure the ATS on page
The steps for accessing the ATS vary, depending on whether the ATS was shipped
from GE or reimaged from the field.
If you received the ATS from GE, use the IP address information on the stickers
to access the ATS.
If the ATS was reimaged in the field, the software reload procedure returns the
ATS IP address settings and computer name to the following factory default
values:
Network Name
IX Address
Unity Address (MC)
Receiver (RX) Address or
OpenNet Address
You have two options:
You can restore the system defaults if they were previously saved.
defaults on page 5-3.
You can configure the standard and specialized functions of the ApexPro
Channelized Telemetry System components.
specialized functions on page 5-4.
ApexPro™ Telemetry
5-2.
5-2.
IP Address Subnet
PrismServer
192.168.1.1 255.255.0.0
192.168.1.2 255.255.0.0
119.1.1.2 255.0.0.0
See Configure standard and
Gateway
192.168.254.254
0.0.0.0
0.0.0.0
See Restore
2001989-203C