Power Trim And Tilt Unit Will Not Operate - Yamaha F225 Owner's Manual

Trouble Recovery
1
11
2 3
4 5 6 7 8 9
1. Fuse box cover
2. Main fuse (100 A)
3. Isolator fuse (100 A)
4. Fuel feed pump fuse (10 A)
5. Main switch / PTT switch / Digital electronic
control ECM (Electronic control module) fuse
(20 A)
6. Shift actuator fuse (15 A)
7. Starting switch (30 A)
8. Ignition coil / Fuel injector / Variable cam-
shaft timing / Engine ECM (Electronic control
module) fuse (30 A)
9. Electric throttle valve fuse (10 A)
10. Fuel pump fuse (15 A)
11. Screw
3 1
2
1. Spare fuse (100 A)
2. Spare fuse (10 A, 15 A, 20 A, 30 A)
3. Fuse puller
4. When replacing a fuse other than the
main fuse or isolator fuse, remove the
100
10
ZMU07195
2
ZMU06961
fuse using the fuse puller. Install a spare
fuse of the proper amperage.
1
1. Fuse puller
Consult your Yamaha dealer if the new fuse
immediately blows again.
EMU40984
Power trim and tilt unit will not
operate
EWM02331
WARNING
Never get under the engine while it is tilt-
ed. Severe injury could occur if the out-
board motor accidentally falls.
If the outboard motor cannot be tilted up or
down using the power trim and tilt unit be-
cause of a discharged battery or a failure
with the power trim and tilt unit, the outboard
motor can be tilted manually.
1. Stop the engine.
2. Loosen the manual valve screw by turn-
ing it counterclockwise until it stops.
ZMU04337