Replacing The Power Supply Unit In The Ksu; Figure 4-22 Connecting Wires To The Psu - NEC Xen Master System Hardware Manual

NEC Australia Pty Ltd
4 - 72
3.9

Replacing the Power Supply Unit in the KSU

The Xen system is supplied with a P64-U13 PSU. The Power Supply
Unit has a battery backup interface and accepts 240 Vac -50Hz and
outputs +5V and –24V to the system.
Before replacing the PSU, remove the defective
!
PSU and verify that the power cord on the
replacement KSU is unplugged.
3.9.1 Installing the P64-U13 PSU
1.
Cable
Connections

Figure 4-22 Connecting Wires to the PSU

Locate the PSU in the space provided and connect
the 8-wire cable from the PSU to the connector on the
backboard of the KSU. Refer to Figure 4-22
Connecting Wires to the PSU.
Xen Master & Xen Axis
Installing KSUs