1.4.2 Creating of Head Calibration Data and Writing it into Flash ROM (Maintenance mode
02)
<Function>
This procedure scans the Print Pattern for Creating Head Calibration Data placed on the
document cover glass, creates the head calibration data using the scanning result, and
writes it into the flash ROM on the main PCB.
<Operating Procedure>
Note
Before proceeding to the procedure given below, use
•
Pattern (Maintenance mode 09)" in this chapter
missing.
Before proceeding to the procedure given below, use
•
Switch Setting (AMS) (Maintenance mode 88)" in this chapter
uneven printing correction for upper and lower ends of the nozzle is set to ON
(Selector 1 on AMS05 is "0").
Before proceeding to the procedure given below, use
•
1.4.15 Acquisition of White/Black Level Data and CIS Scanner Area Setting
(Maintenance mode 55) in this chapter
precision printing.
Make sure that both the document scanner unit and document cover are closed.
•
For higher precision of uneven printing correction, it is recommended to use the
•
recording paper specified below to print the pattern for creating head calibration
data.
US: Xerox 4200DP 20 lb., Brother BP60PL
EU, AP and others: Xerox Business 80 g/m
(1) Save a copy of "head_calib_BHmini13_Low.prn" in the arbitrary folder.
(2) Enter maintenance mode, and connect your PC to the machine using a USB cable. On
your PC, launch Filedg32, select the maintenance driver, and drag and drop the
above-mentioned prn file to print.
Note If the document gets stained or crinkled, print it again.
(3) Set the print pattern for creating head calibration data on the document cover glass.
Set the pattern so that the
of the document cover.
Note If the Document cover glass gets stained, clean it.
(4) Enter [0] and [2] in the initial stage of the maintenance mode. The machine displays
"Set Sheet on FB?" on the LCD.
Note Pressing [Stop] or [X] returns the machine to the initial stage of the maintenance
mode without creating head calibration data.
(5) Press [Mono Start].
The machine displays the "Scanning" on the LCD and starts scanning the print pattern
for creating head calibration data placed on the scanner glass.
to enable the machine to make high
2
, Brother BP60PA
mark on the upper left of the document fits on the left rear
5-7
"1.4.5 Printout of Test
to check that there is no pin
"1.4.32 Assurance Mode
to check that the
Confidential