Connect Analog Room Control Unit - ABB i-bus KNX Product Manual

®
ABB i-bus KNX
Parameters
7.11.1.5.6 —
Dependent parameter
Scan input after download, ETS reset and bus voltage recovery
Options:
•
no: The object value is not scanned after a download, ETS reset or bus voltage recovery.
•
yes: The object value is scanned after a download, ETS reset or bus voltage recovery.
Scanning starts once the device is ready for normal operation again after the download, ETS reset or bus
voltage recovery. This can take up to 2 seconds.
7.11.1.6

Connect analog room control unit

In the Setpoint adjustment parameter window, you can set the Connect analog room control unit to
physical device input a parameter to allow an analog room control unit to be connected to the input.
You will not be able to change this in the Input a window unless you deactivate your selection in the
Setpoint adjustment window first.
This setting displays the dependent parameters Send Status value and Send input status cyclically.
7.11.1.6.1 —
Dependent parameter
Send status value
Options:
•
After a change: Sends the value only after a change.
•
After a change and cyclically: Sends the value after a change, and cyclically. Enables the dependent
parameter Send input status cyclically.
No
Yes
Note
After a change
After a change and cyclically
VC/S 4.x.1 | 2CDC508220D0211 Rev. A 195