System Programming - Honeywell 301C User Manual

System Programming

Programming Interface
The system's Normal programming mode offers several menu options
that are accessible from the main menu screen:
Tx Info: Allows you to program transmitter parameters
Groups: Allows you to set up groups of transmitters
Events: Allows you to program events and event behavior
Acqui: Allows you to activate or deactivate the datalogging feature
Copy: Allows you to copy data or parameters from the (controller)
configuration to parameters
Config: Allows you to set system parameters and password
Network: Allows you to perform actions on the network, consult
communication statistics and perform remote calibrations
Tests: Allows you to test each device sequentially (inputs, outputs,
communications, events, etc.) and validate operation of
various parameters
BACNet: Allows you to set a device's BACNet parameters
Wireless: Allows you to configure, monitor and modify a network of
wireless gas detection devices.
Note: Access to the programming functions is password protected.
The default password is 2967.
When you first begin, the screen display appears as follows, scrolling
between information screens for each device connected to the
controller:
If one or more of the connected devices is in an alarm mode, the
controller will only scroll between the main information screen and the
screens for device(s) in alarm mode. In this case, you must scroll
manually to view screens for other devices.
24
System Programming
VA301C
Ad: 1
2007-01-17
301C User Manual
Honeywell
Ver. 3.00
Gr:0 Ev:0
13:18:18
510324
4/07