Remove Entire Cabinet - Maytag MAT14CS Service Manual

Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
1. Remove the control panel (see page 4-1).
2. Remove the two wire connections from the
control board that go into the metercase.
PD model is shown here. On CS models
unplug the timer wire harness connections.
Two wire
connectors
3. Remove the two wire connections to the
transformer, one Molex plug and one
connection on the control board.

reMOve eNTire CaBiNeT

Molex plug
4-17
Transformer wire
connector plug
4. Remove the 5/16 inch hex head screw
securing the ground wire that goes to the lid
switch.
5. Remove the wire harness connector plug to
the lid switch.
Lid switch wire
connector
Lid switch
ground wire