Table of Contents
Advertisement
Setting Network Address
Description
Before You Begin
Command Line
Definitions
Instructions
2000585-001
This section provides instructions to configure an Advance DataNET 'A'
or 'B' Hub with its own Network Address.
1. Connect a standard 9-pin COM cable from the designated PC COM
(see page 49, step 7.) to Hub 'A' or 'B' Configuration Port located on
the Communications Board.
2. Open Windows HyperTerminal program on your PC; reference Con-
figuring Your PC, page 49.
3. Connect and Log on to DNH; reference Establishing a Connection,
page 54.
Chapter 4, Command Line Summary, provides definitions for all of the
commands you will be using in this chapter.
1. Log on locally to the DNH.
The Connect Screen will appear with the login information and the
local prompt. The local prompt indicates that your are communicating
with the DNH connected directly to the PC.
Data Communications Setup • • • • 57
Advertisement
Table of Contents
