Honeywell EVCS-CMPT9 Installation, Commissioning And Maintenance Manual page 20

Scroll to the Outstn settings menu and press TICK. This menu consists of a list of all 20 possible lines (M1 through M9 on the
Outstation Settings
EVCS-CMPT9 master unit, and S1 through S10 on the EVCS-XC10 slave unit, plus a back option. The outstation location is
Select outstation
shown with the outstation line number, along with a symbol:
S10-outstation 10
> Back
M9-Outstation 1
Unlocked: this outstation exists.
Line through circle: this outstation does not exist or is in fault.
Select the outstation to be configured and press TICK.
M9-outstation 1
This shows a sub menu for each outstation
Back
>Settings
Name
Settings
M9-outstation 1
O'stn not detected
Kind>None
:Next
The second line of the display indicates the status of the extension (present or not detected).
Kind allows you to set the outstation type:
None (no outstation),
Phone (Type A handset),
Refuge (Type B handsfree handset),
Pullcord (disabled toilet alarm).
If an outstation is defined as a Pullcord, the master will emit a continuous tone if the toilet alarm is activated. This tone will cease
when the master handset goes off hook. No call can be established with the toilet alarm.
Set Name
M9-outstation 1
Name
>Extension 1 <
:Next
Use the navigation keys to change the first character of the extension name, and press TICK to move to the next character.
Repeat for all characters. Press TICK on the last character to move the cursor onto Next.
Use navigation keys to select Next, Save, or Quit, and press TICK to select option.
Note: if the memory is protected (locked padlock symbol shown for the exchange), then you will only be able to view this
information.
The cursor will be on the Quit option. Only Next and Quit can be selected. Pressing Quit will move back to the select outstation
menu.
www.acornfiresecurity.com
19
www.acornfiresecurity.com