Cisco AIRONET 340 SERIES Quick Start Manual page 7

Follow these steps to install the utilities:
After you have installed the appropriate driver for your system, you can install the Cisco
Aironet Client Utilities (ACU), Link Status Meter (LSM), and Client Encryption Manager
(CEM) utilities. Installing utilities is optional unless using Wired Equivalent Privacy (WEP) in
your network. If WEP is enabled, all devices in the network must have the same WEP code,
which you set using the CEM utility. The ACU and LSM utilities provide troubleshooting and
status information, but are not required.
1
Insert the CD-ROM for your operating system into your computer CD-ROM drive.
2
Select Start > Run and enter the following path (where D is the letter for your CD-ROM
drive): D:\utils\setup.exe
3
Follow the setup instructions on the screen to complete the installation.
Refer to Software Configuration Guide on the Client Adapter CD for instructions on how to
use each utility.
Note: After you have installed the appropriate driver and utilities, contact your IS department
if you have a problem connecting to the network.
5