Setting The Clock - Sharp MD-MX20 Operation Manual

SETTING THE CLOCK

ON/STAND-BY
CLOCK
In this example, the clock is set for the 24-hour (0:00) sys-
tem.
1
Press the ON/STAND-BY button to turn the power on.
2
Press the CLOCK button.
3
Within 5 seconds, press the MEMORY/ENTER button.
4
Turn the jog dial to select the time display mode.
"0:00" The 24-hour display will appear.
(0:00 - 23:59)
"12:00 AM" The 12-hour display will appear.
(AM or PM 12:00 - 11:59)
"0:00 AM" The 12-hour display will appear.
(AM or PM 0:00 - 11:59)
Note that this can only be set when the unit is first in-
stalled or it has been reset (see page 38).
5
Press the MEMORY/ENTER button.
6
Adjust the hour by turning the jog dial.
MEMORY/
ENTER
When the jog dial is turned one click clockwise, the time
Jog dial
will increase by 1 hour. When it is turned one click coun-
terclockwise, the time will decrease by 1 hour.
Keep turning the jog dial to change the time continuously.
When the 12-hour display is selected, "AM" will change
automatically to "PM".
7
Press the MEMORY/ENTER button.
8
Adjust the minutes by turning the jog dial.
When the jog dial is turned one click clockwise, the time
will increase by 1 minute. When it is turned one click coun-
terclockwise, the time will decrease by 1 minute.
Keep turning the jog dial to change the time continuously.
The hour setting will not advance even if minutes advance
from "59" to "00".
9
Press the MEMORY/ENTER button.
The clock starts operating from "0" second.
(Seconds are not displayed.)
To see the time display:
Press the CLOCK button.
The time display will appear for about 5 seconds even in
the stand-by mode.
Note:
The "CLOCK" will appear at the push of the CLOCK button
when the AC power supply is restored after a power failure
occurs or after the AC power cord is disconnected.
If this happens, follow the procedure below to change the
clock time.
1
To change the clock time:
2
Press the CLOCK button.
3
Within 5 seconds, press the MEMORY/ENTER button.
Perform steps 6 - 9 above.
1
To change the time display mode:
2
Reset the microcomputer (see page 38).
Perform steps 2 - 9 above.
11