Image Projection; Switching The Input Mode; Adjusting The Projected Image - Sharp XV-Z20000 Operation Manual

Image Projection

Switching the Input
Mode
Select the appropriate input mode for the con-
nected equipment.
Press Input Mode Select buttons or
INPUT on the remote control to select
the input mode.
• When
INPUT on the remote control or
INPUT on the projector is pressed, the Input
list appears. While the Input list is displayed,
follow the procedure below to switch the Input
mode.
Press INPUT or
input mode.
Press ENTER.
• If
ENTER is not pressed, the projector
switches to the selected input mode in a
few seconds.
Note
• When no signal is received, "NO SIGNAL"
will be displayed. When a signal that the
projector is not preset to receive is received,
"NOT REG." will be displayed.
Adjusting the Projected
Image
1. Adjusting the Focus
You can adjust the focus with the focus ring on the
projector.
Rotate the focus ring to adjust the focus while
watching the projected image.
2. Adjusting the Image Size
You can adjust the image size using the zoom knob
on the projector.
Move the zoom knob to enlarge or shrink the
image size.
/ to select the desired
Adjustment
buttons
( / )
Input Mode Select buttons
INPUT
Input mode menu
Focus ring
Zoom knob
ENTER
-27