Table of Contents
Advertisement
Chapter 14: Support Tools
The following support tools are available to record (store), and load the contents of the parameter
memory.
(Make sure to save the set parameters onto a floppy diskette.)
Model name
Ladder software (JW-92SP, JW-50SP)
Multipurpose programmer (JW-50PG)
Ladder processor II (Z-100LP2S)
Record and load by ladder software (JW-92SP, JW-50SP)
<Record>
(1) Stop operation of the JW-21MN
Select "PC TRANS."
Select "Read."
Select "DL. M. stn. PARAM." or "DL. S. stn.
PARAM."
When the connected JW-21MN is master station, select "DL.
M. stn. PARAM." When the connected JW-21MN is slave
station, select "DL. S. stn. PARAM."
After selecting "PC stop," press the "Enter"
key.
(2) Record onto the personal computer
After stopping operation, record the parameters of the JW-21MN onto the memory of the personal computer.
Select "Read out PARAM" and press the "Enter" key.
Start reading to memory of the personal computer.
(3) Start operation of the JW-21MN
After recording the parameters onto the personal computer, start operation of the JW-21MN.
Select "Start operation."
Start operation of the JW-21MN
(4) Record onto a floppy diskette
Write (record) the memory contents of the personal computer onto a floppy diskette.
Select "FD TRANS."
Select "Save."
Select "DL. M. PARAM." or "DL. S. PARAM."
When the memory contents of the personal computer are for a master station, select
"DL. M. PARAM." When the memory contents of the personal computer are for a
slave station, select "DL. S. PARAM."
Input a file name to record.
Input comments.
Press the "Enter" key.
Start recording onto the floppy diskette.
Applicable floppy diskettes
3.5-inch 2DD/2HD, 5-inch 2DD/2HD
3.5-inch 2DD
3.5-inch 2DD
JW-50SP
14-1
JW-21MN
Connection cable
JW-22KC/24KC
14
Advertisement
Table of Contents
