Table of Contents
Advertisement
(2) Parameter setting by remote function
This paragraph describes how to set the parameters of other stations' network module (JW-21MN/
JW-20MN) connected on the ME-NET. This is only available when the target station is within the
standard network connection.
Usable support tools are JW-14PG/13PG/12PG.
< An operation example using the JW-14PG >
Connect the programmer to the JW-21MN
on the ME-NET.
Select initial mode.
Assign the parameter setting remotely.
Select the target station to set the parameter remotely.
Communication with the target station.
After finishing communication with the target station, set the parameters remotely.
- Turn the PC of the target station to program mode (stop PC operation).
- Select "PARAM." in the initial mode.
16
→
Display the contents of the address and then set the parameters.
Write 81
EEPROM of the JW-21MN. Then start operation of the JW-21MN.
(3) Compatible with file register for file 10 to 2C (compatible with the JW-33CUH2/3)
1) When used with a data link
[File 10 to 2C
flag range.
2) When used with a computer link
[File 10 to 2C
write to a register (command 34
→ Display initial mode.
→
Select "LINK" in initial.
→
Select display mode of "1PG, 2PG1 MODE" in specified link.
Select target station." in 1PG, 2PG1 MODE.
→
Change the code from hexadecimal
→
station (00
to 77
(8)
(8)
→
Initiate communication with the target station.
→
Return to initial menu.
(Input address)
in parameter address 007777
(H)
] (SEG10 to 2C) can be assigned as the top address of the register link area and
(H)
] (SEG10 to 2C) can be used to read the current register value (command 24
(H)
(H)
display to octal
(H)
).
Display the contents of parameter address
→
007777
.
(8)
Write 00
to stop operation of the JW-21MN.
(H)
(Enter the set value)
, and then write the parameter contents into the
(8)
), or write to the same data register (command 35
16-16
(JW-21MN)
display and input the target
(O)
(H)
).
(H)
),
Advertisement
Table of Contents
