Initial Settings Of The Camera - Sony BVP-900 Series System Manual

3-2-10 Initial Settings of the Camera

Set the adjustment mode or compensation mode of the
camera. Setting is done by displaying the CAM Mode
display on the MSU-700A/750.
Displaying the CAM Mode Setting display
MODE
MULTI
CARD
CONFIG
MAINTENANCE
FILE
PAINT
CONFIG button
Menu operation block of the MSU-700A/750
1
Press and light the CONFIG button in the MODE
block of the MSU-700A/750.
Configuration Menu appears.
Configuration Menu
Camera CCU
CNU MSU
2
Press [Camera].
The CAM Mode Setting display appears.
Page 1
CAM Mode Setting
Exit
1/2
OHB
Test2 Mode White Setup Mode Matrix
Correct
Auto
3Step 10Step AWB ON
Level
White/
Auto White
Gamma
Shading Mode
RGB
RGB RB Only ON
Page 2
CAM Mode Setting
Exit
2/2
V Detail Creation Mode
RGB
G R + G V
NAM
V Detail Control
Mode
H/V V Only
Making settings
Selecting the output signal in test 2 mode
Select the output signal in test 2 mode, tri-level
waveform or ten-level waveform, in Test 2 Mode
section.
To select a tri-level waveform: Press [3Step] to set it
in inverse video.
To select a ten-level waveform: Press [10Step] to set
it in inverse video.
Setting the white-balance adjustment mode
Select the status of the white balance when the paint is
cleared or the standard button is pressed in White
Setup Mode section.
To retrieve the auto-white-balance adjustment
value just before the button is pressed: Press [AWB]
to set it in inverse video.
To retrieve the reference value (displayed value: 0):
Press [Auto Level] to set it in inverse video.
Setting the auto white shading mode
Select the status of the R, G and B channels when the
auto white shading is executed in Auto White Shading
Mode section.
To automatically adjust the R, G and B channels to
be flat: Press [RGB] to set it in inverse video.
To automatically adjust the shading waveform of
the R and B channels to be the same as that of the
G channel: Press [PB Only] to set it in inverse video.
Setting the compensation of the OHB file
Select whether the matrix correction of the OHB file is
activated or not in OHB Matrix Correct Mode section.
Each time the button is pressed, ON and OFF settings
are toggled. When ON is selected, the matrix
correction is activated.
Setting the white gamma
When the setting in the White/Gamma RGB section is
set to ON, the reference file settings for the R, G, and
B channels are displayed "0" on the automatic level
adjustment.
When set to OFF, the R and B channels are adjusted
referring the G channel, and the settings are dsipalyed
"0."
Each time the button is pressed, ON and OFF settings
are toggled.
Factory setting: ON
3-61
Chapter 3 Initial Settings