Table of Contents
Advertisement
Arranging System Components
To increase editing efficiency, take the following
points into consideration when installing the
EditStation.
• Place the video monitor on the left side of the
operator and the computer monitor
• Operate the control panel with the left hand and the
mouse or tablet with the right hand.
• Place the ES-7 main unit
be easily accessible, according to the space available
in your work environment.
..........................................................................................................................................................................................................
1) If you wish to install the ES-7 main unit at a distance
from the computer monitor, use a multi-cable with a D-
sub 15-pin connector on one end and 5 BNC cables on
the other end. Use 5 BNC extension cables, connected to
the BNC connectors of the multi-cable. Always use BNC
extension cables of the same length and characteristics.
If the cables are of different lengths, the phase of the
output signals from the BNC connectors will not be the
same. Use of a multi-cable extension cable is
recommended. However, note that picture quality may
decline if the extension cable is too long.
1)
on the right side.
2)
and VCRs where they will
Preview
monitor
Control panel
Arrangement of system components
Work desk
Computer monitor
Mouse or tablet
Keyboard
Operator
2) To allow the ES-7 main unit to be installed at a distance
from the mouse and keyboard, connect the supplied 4-
meter keyboard and mouse extension cables to the
regular keyboard and mouse cables. A 5-meter
connection cable is supplied for the control panel.
Chapter 3 Connections and Settings
63
Advertisement
Table of Contents
