Operating Instructions - Black & Decker Matrix BDCMTR Instruction Manual

To remove blade from saw:
WarNiNg:
Burn hazard. Do not touch the the blade
immediately after use. Contact with the blade may result in
personal injury.
1. Open blade clamp release lever to its full open position as
shown in figure a.
2. Remove blade.

OPeraTiNg iNsTrucTiONs

WarNiNg:
Always use proper eye protection that conforms to ANSI Z87.1(CAN/CSA
Z94.3) while operating this power tool.
NOTe:
Before cutting any type of material, be sure it is firmly anchored or clamped to
prevent slipping.
• lightly place blade and and firmly press shoe against work
to be cut.
• To switch the tool on, press the variable speed switch on the
power unit. The tool speed depends on how far you press
the switch.
• Obtain maximum speed before applying pressure.
• Always hold saw firmly with both hands while cutting as
shown in figure B. whenever possible, the saw shoe
must be held firmly against the material being cut. This will
prevent the saw from jumping or vibrating and will minimize
blade breakage.
• To switch the tool off, release the variable speed switch.
• Always use the appropriate type of saw blade for the workpiece material and type of cut.
• If necessary, drill a hole in the workpiece near the starting point of the cut so the blade will fit
before starting the cut.
NoTE: This attachment only operates in the forward direction, the forward/reverse slider of the
power Unit should not be able to be switched to reverse.
FluSh cutting (FiguRe c)
• The compact design of the recipro c ating saw motor housing and
pivoting shoe permit close cutting to floors, corners and other
difficult areas.
• Turn the saw upside down so you are as close to the work
surface as possible.
• Always hold saw firmly with both hands while cutting as shown in
figure c.
wood cutting (FiguRe d)
• Before cutting any type of wood, be sure the work piece is
firmly anchored or clamped to prevent slipping.
• lightly place blade and and firmly press shoe against work
to be cut.
• Switch on saw motor before applying pressure.
• Always hold saw firmly with both hands while cutting.
whenever possible, the shoe must be held firmly against the
material being cut. This will prevent the saw from jumping or
vibrating and minimize blade breakage.
A
B
D
4
4
C