Restoring The Application - Fujitsu TeamPad500 System User Manual

TeamPad 500 User's Guide

5 Restoring the Application

When data is lost from memory (RAM) because of a low battery situation, the application operating
environment can be automatically restored. This function is only relevant for files that are installed
using the Application "Setup Menu" (for details, see Section 3). Note that files that were copied to
their location via Explorer are not restored. The state of the unit is returned to that at Install time.
The Restore process starts up automatically when data is erased in memory because of a dead
battery. When the unit is restarted/powered on, the following Window will be displayed.
To begin the restore procedure: Hold down the ENT/SYS key, then press the "1" Key to start the
Touch Panel calibration.
To stop the restore procedure: Turn off the power by pressing the power key.
Copyright 2001 by Fujitsu-ICL Systems Inc.
44 of 47