Features And Controls - Craftsman CMXGGAS030733 Operator's Manual

Compare the illustrations with your generator to familiarize yourself with the locations of various controls and product warnings .
On/Off Switch
120 Volt AC, 20 Amp, GFCI Duplex Receptacles — Used
to supply 120 Volt AC, single phase, 60 Hz power for
electrical lighting, appliance, tool and motor loads .
120/240 Volt AC, 30 Amp Locking Receptacle — Used to
supply 120 / 240 Volt AC, single phase, 60 Hz power for
electrical lighting, appliance, tool and motor loads .
Circuit Breakers — The 120 Volt AC, 20A GFCI duplex
receptacles are provided with "push to reset" 20 Amp
circuit breakers to protect the generator against electrical
overload .
CO Guard™ Carbon Monoxide (CO) Shutdown Indicator
Light — Indicates the engine shutdown due to carbon
monoxide accumulation around the generator or a CO
Guard system fault occurred .
Start Switch
Circuit Breakers
Low Oil
Shutdown
CO Guard™
Carbon Monoxide
(CO) Shutdown
Indicator Light
120/240 Volt AC, 30
Amp Locking Receptacle
120 Volt AC, 20 Amp
GFCI Duplex Receptacles
Low Oil Shutdown — This unit is equipped with a low oil
protection device . Oil must be at proper level for engine
to run . If the engine oil drops below a preset level, an oil
switch will stop the engine . Check oil level with dipstick .
Main Breaker — Protects generator against electrical
overload . If breaker trips, it cuts power to all receptacles .
On/Off Switch — Set this switch to ON (I) before starting
engine . Set switch to OFF (0) to shut off engine .
Start Switch — Push and hold in "Start" position for a
maximum of 5 seconds during each start attempt, until
engine starts .

Features and Controls

Main Breaker
5