Table of Contents
Advertisement
For details on verifying the setting, see "To configure
system control settings" (page 70).
[RS-232C]
Specify the device connected to the RS-232C connector.
The default setting is [No Device].
If you selected [System Control], be sure to configure the
transmission speed under [System Control Setting].
For details on this setting, see "To configure system
control settings" (page 70).
[Remote Startup]
Select whether to link the power on/off operations of
remote systems via USB port 7 and the RS-232C
connector.
The default setting is [Do Not Start].
When [USB 7] or [RS-232C] is selected, the remote
system's on/off operation will be linked to that of the unit
via the selected connector.
To configure system control settings
Display or configure the transmission speed when
performing system controls via USB port 7 or the
RS-232C connector.
1
Select [Advanced] for [USB 7] or [RS-232C], and
press the ENTER button.
[Advanced] appears when [USB 7] or [RS-232C] is
set to [System Control].
The [System Control Setting] screen appears.
2
Select the transmission speed, select [Apply] and
press the ENTER button.
For USB port 7, the transmission speed is fixed at
115200 bps.
For the RS-232C connector, you can select from
9600 bps, 19200 bps, 38400 bps, 57600 bps, and
115200 bps for the transmission speed.
The default setting is [9600 bps].
The configurations are saved, and the [Control] tab
appears again.
[Contact Switch] Tab
Configure these settings when you want to control the
unit via contact switch devices connected to the contact
switch connectors on the rear panel of the unit.
1
Select the control items for [Contact Switch 1] to
[Contact Switch 3].
Specify what will be controlled via the contact switch
device for each contact switch.
The procedure for configuring [Contact Switch 1] to
[Contact Switch 3] is the same.
The default setting is [Not Used].
[Not Used]
Disable use of the contact switch device.
[Record Video/Pause]
Control pause and resume functions while recording
videos.
[Record Still]
Capture still images.
[Audio On/Off]
Enable or disable audio output.
[Set Index]
Add an index without saving a still image of the
recording.
2
Select [Advanced] for the contact switch that will
perform the control, and press the ENTER button.
The [Advanced] settings screen appears.
3
Specify the control timing, select [Apply] and press
the ENTER button.
You can select from [Falling Edge], [Leading Edge],
and [State].
The default setting is [Falling Edge].
[State] cannot be selected when the control item is set
to [Record Still] or [Set Index].
Tip
The pause control of the [Record Video/Pause]
function will not operate immediately after recording
starts. Wait about 5 seconds before performing the
control.
The [Contact Switch] tab appears again.
70
Advertisement
Table of Contents
