System Screen
Makes basic settings for the unit.
Board tab
Makes input/output board settings using a setup wizard.
Click the [Setting] button at the bottom of the screen to
start configuration.
For details about settings, see "Setting the System and
Boards" (page 13).
Step 1
Sets the system frequency of the unit.
• 23.98 Hz
• 24 Hz
• 25 Hz
• 29.97 Hz
Step 2
Sets the mode for each of the ports (A to D).
• Input
Setup tab
Makes basic operating mode settings of the unit.
20
System Screen
• Output
• HD Input Multi (dual-system input)
• HFR (High Frame Rate) Input (high frame rate
recording)
• HD Cut Out (for 4K/QFHD video HD cutout)
For high frame rate recording (HD 300p/359p, 4K 100p/
119p), two boards are used.
No audio signal is recorded if high frame rate recording is
selected.
Step 3
Sets the video codec of each port.
Select the codec using the radio buttons.
Step 4
Sets the video format of each port.
Select the format to use from the matrix.
Step 5
Sets the sync operation of each port.
Select the grouping to use from the pull-down menu.
Step 6
Check the settings made in steps 1 to 5, and submit the
settings.