Table of Contents
Advertisement
Model IFP-2100/ECS Installation Manual
Pressing Select Key 5 will start a playback of the recorded message.
Press
Select Key 5
to record to
this
message
slot
11.8.3
Erasing User Message
To erase the message stored in message slot 1-15, follow these steps:
1.
Enter programming mode at main control panel.
2.
Select 8 for Voice Options.
3.
Select 1 for VCM Maintenance.
Note: The VCM will light the green Select Key LEDs for message slots that are occupied (can be erased).
4.
Select 2 Local Recording.
5.
Select the amplifier and circuit for the audio to play through during programming. A user would generally
pick the audio circuit that is in closest proximity to them.
6.
Press ECS Message Key 8 on the VCM, press the Select Key 1-15 that you wish to erase. The Select Key red
LED will stay on until the erase is done. When erased, the Select Key green LED by corresponding to the
message slot you erased will go off.
11.8.4
Using HFSS Voice Message Load Software
The HFSS Voice Message Load Software is a software support utility that is used to download recorded
messages (in .SKE format stored on your PC hard drive) to the various message locations of the ECS-Series
VCM or ECS-NVCM. Messages can be uploaded from the ECS-VCM or ECS-NVCM, stored, and used again in
similar installations.
To read/write .SKE formatted messages to and from the main panel, follow these steps:
1.
Make sure that panel is in Normal mode.
Figure 11-7 Recording with Microphone Example
11-15
LS10143-001SK-E
Press
ECS Message
Key to enter
message slot
selection
mode
Advertisement
Table of Contents
Troubleshooting
