Chapter 4 Disassembly/Reassembly Procedures; Disassembling And Reassembling The Pager - General; Maintenance - Motorola MINITOR VI Basic Service Manual

Chapter 4 Disassembly/Reassembly Procedures

!
C a u t i o n
4.1 Disassembling and Reassembling the Pager – General
When disassembling and reassembling the pager, it is important to pay particular attention to the
snaps and tabs, and how parts align with each other.
The following tools are required for disassembling the radio:
™
• TORX
• Pry Opener (6686119B01)
• Crab Eye Nut Tool (PMDN4039_R)
• Knob Remover (PMDN4038_R)
The following item and tools are required for reassembling the radio:
• Screw fastener: 3 bond (TB1401B)
! !
W A R N I N G
• Crab Eye Nut Opener (PMDN4039_R)
• Grease (1180369B40)
™
• TORX
If a unit requires further testing or service than is customarily performed at the basic level, please
send the radio to a Motorola Service Center listed in Appendix A.
4.2

Maintenance

The procedures in this section provide instructions for the disassembly of the MINITOR VI pager.
This product contains static-sensitive devices. Use anti-static handling procedures to prevent
electrostatic discharge and component damage.
Only Motorola Service Centers or Authorized Motorola Service Dealers can
perform this function.
T6 and screwdriver
Only use TB1401B (Manufacturer; Threebond) paint. Do not to use other
lock paint as they might harm the PC resin of the pager.
T6 and screwdriver