Halsey Taylor HWF172 Water Sentry VII Installation Instructions

MODEL HWF172 Water Sentry VII™
GENERAL
Designed to remove cysts, such as
cryptrosporidium and giardia, lead particles
and chlorine. Also reduces odors and
discoloration from incoming water.
Features include Quick-Disconnect,
installation. Automatic inlet shut-off valve that
closes when filter is removed. Outer protective
wrap. Spun Polypropylene prefilter mesh to
prevent large, coarse sediment and particles
from entering and clogging filter media.
High-grade filter is made with activated carbon
and patented ATS lead-removal media. Radial
flow-thru design provides more surface area
for untreated water while final filter mesh pre-
vents loose carbon from entering water. Cap
and housing shall be made of rust and corro-
sion free plastic. Lead and cyst reduction filter
shall be Halsey Taylor Water Sentry VII.
Designed specifically for use with the
following series of Halsey Taylor water coolers:
HAC, HACBL, WM**, SCWT** series, S series
and WMBL. Can also be used on OVLSER,
OVLER, HRF, RC & BFMR units but must be
mounted into the wall behind the unit's
backplate. CANNOT be used in the HTV, SW,
WC, HBW or the unrefrigerated versions of the
HRF and OVL series.
** For water cooled models contact the factory.
RECOMMENDED USE CONDITIONS
Capacity......................1,500 Gallons (5678 £)
Flow rate .....................0.75 gpm (2.8 l/m)
Temperature ................40-120°F (4 - 49°C)
Maximum Pressure .....105 psi (724 Kpa)
Minimum Pressure ......20 psi (138 Kpa)
PERFORMANCE TEST CONDITIONS*
Capacity......................1,500 Gallons (5678 £)
Flow rate .....................0.75 gpm (2.8 l/m)
Pressure ......................60 psi (4.2 Kg/cm
Temperature ................68-70°F (20-21°C)
*Performance will vary depending on local water conditions.
WATER CONNECTION
•
Water Inlet for 3 ⁄ " O.D. Tube
8
•
Water Outlet for 1 ⁄ " O.D. Tube
4
STANDARDS
This filter has been tested to the following NSF
International standards: NSF/ANSI Standards
42 Chlorine, Particulate, and Taste and Odor.
NSF/ANSI Standard 53 for Reduction of Lead
and Cyst.
KIT CONSISTS OF:
■ Filter
■ Filter head
■ Mounting bracket
■ 1/4" polytubing, connectors and screws
■ Installation instructions
■ Performance Data Sheet
4 lbs.
Shipping Weight:
HALSEY TAYLOR,
55897C REPLACEMENT FILTER
Replacement filter for Water Sentry VII.
Replacement instructions included. Filter
should be replaced every 1,500 gallons (5678
liters) or approximately one (1) year after
installation. Use part # 55897C when ordering
1 ⁄ turn
4
replacement filter.
98262C FILTER MONITOR
Optional accessory monitors the number of
gallons used for determining when to change
filter. When a filter change is due, the monitor
will beep when water is flowing. Monitor
operates on 2 AA alkaline batteries (not
included). Installation instructions included.
NOTE: Continued product improvement makes
specifications subject to change without
notice. See Halsey Taylor website for most
current spec sheet.
2 )
JOB NAME:
ENGINEER/CONTRACTOR NAME:
APPROVAL:
DATE:
halseytaylor.com
, 2222 CAMDEN COURT, OAK BROOK, ILLINOIS 60523
DIV. OF ELKAY MFG.
Cyst and Lead
Reduction Filter
HWF172
Replacement Filter
55897C
Filter Monitor
98262C
E12 /
11-2007