Frigidaire BASELINE Series Use & Care Manual page 8

INSTALLATION
CAUTION
Do Not loosen or remove these 3 hex screws.
Cabinet Leveling & Refrigerator
Door Alignment (if necessary)
Guidelines for final positioning of your refrigerator:
• All four corners of the cabinet must rest
firmly on the floor.
• The front should be slightly elevated to
ensure that doors close and seal properly.
• Doors should align with each other and
be level.
Most of these conditions can be met by raising
or lowering the adjustable front rollers.
To level the cabinet using the front rollers:
1 Slightly open freezer drawer if the toe grill
is installed. Lift the toe grille and gently
pull forward.
2 Make initial cabinet adjustments by using
the front roller height adjusting screws.
Use a 3/8 inch socket wrench to turn the
adjustment screws (1 per side).
8
DO NOT
Loosen
or
Remove
These 3
Hex
Screws
3 Ensure both doors are bind-free with their
4 After unit is leveled, lower anti-tip leg
5 Install the toe grille by fitting into place.
To raise: turn adjustment screw clockwise.
To lower: turn adjustment screw
counterclockwise.
Anti-tip
Leg
seals touching the cabinet on all four sides
and that cabinet is stable.
using a 3/8 inch socket wrench until it
firmly contacts the floor.
Toe Grille Must
Fit in Slot on
Anti-tip Bracket
Screw/Washer
Assembly
(2) Retaining Clips
Raise
Lower