Specify A Pppoe Internet Connection That Uses A Login - NETGEAR BR500 User Manual

12. Click the Test button to test your Internet connection.
If the NETGEAR website does not display within one minute, see You cannot access
the Internet on page 153.

Specify a PPPoE Internet connection that uses a login

To specify or view the settings for an ISP Internet connection that uses PPPoE and
that requires a login:
1. Launch a web browser from a computer or mobile device that is connected to the
router network.
2. Enter https://www.routerlogin.net.
Your browser might display a security message, which you can ignore. For more
information, see Log in to the local browser interface on page 16.
A login window opens.
3. Enter the router user name and password.
The user name is admin. The password is the one that you specified when you set
up your router. If you didn't change the password, enter password. The user name
and password are case-sensitive.
The Dashboard displays.
4. Select BASIC > Setup > WAN Setup.
The WAN Setup page displays.
5. Select the Yes radio button.
The settings on the page change.
6. From the Internet Service Provider menu, select PPPoE as the encapsulation
method.
7. In the Login field, enter the login name that your ISP gave you.
This login name is often an email address.
8. In the Password field, enter the password that you use to log in to your Internet
service.
9. If your ISP requires a service name, type it in the Service Name (if Required) field.
10. From the Connection Mode menu, select Always On, Dial on Demand, or Manually
Connect.
11. If you select Dial on Demand from the Connection Mode menu, in the Idle Timeout
(In minutes) field, enter the number of minutes until the Internet login times out
Specify Your Internet Settings
Manually
Insight Instant VPN Router BR500
24 User Manual