Makita GC01 Instruction Manual page 11

► 1. Holder
4. Attach the rubber ring, nozzle, and holder cap by
turning the holder cap firmly.
1 2 3 4
► 1. Holder cap 2. Nozzle 3. Rubber ring 4. Holder
5. Push the rod gently until the piston touches the
package.
To remove the package, remove the holder cap, nozzle,
rubber ring, and then push the rod handle forward until
it stops.
Direct filling
NOTICE:
Make sure that 600 ml (20 fl oz) holder
is attached to the holder joint and piston C is
attached to the rod. Do not use other type of
holder and piston for direct filling.
1. Remove the holder cap, nozzle, and rubber ring
from the holder.
1 2 3 4
► 1. Holder cap 2. Nozzle 3. Rubber ring 4. Holder
1
2. Push the rod handle all the way until it stops.
3. Insert the tip of the holder into the caulking mate-
rial, and then pull the rod handle slowly to fill the holder
with the caulking material.
1
► 1. Holder
4. Attach the rubber ring, nozzle, and holder cap by
turning the holder cap firmly.
1 2 3
► 1. Holder cap 2. Nozzle 3. Rubber ring 4. Holder
Caulking operation
Pull the trigger to feed the caulking material. Put one
hand under the holder to support the tool while operat-
ing it.
After the operation, wipe off the caulking material from
the tool. Be sure to remove the caulking material before
it becomes solid.
NOTE: At the beginning of operation, set the speed
adjusting dial to "1" and pull the switch trigger slowly
to check how much amount of caulking material is
fed.
NOTE: Depending on the type and conditions of
caulking material, it may not be fed at low speed. In
this case, set the speed adjusting dial higher.
11 ENGLISH
4