When Setting Indoor Unit Control Pcb Switch For Wall-Mounted Indoor Unit - Sanyo C4272R S/C Installation Instructions Manual

07-115 SSHP_II 5/7/07 4:00 PM

7-23. When Setting Indoor Unit Control PCB Switch for Wall-Mounted Indoor Unit

When using either the wired or wireless remote controller, refer to the tables below and accordingly slide the switch on
the indoor unit control PCB.
G If this setting is not made correctly an alarm will occur. (The operation lamp on the display blinks.)
G This setting is not necessary if both the wired remote controller
and wireless remote controller are used.
However, when you use indoor unit KHS type, set the wired
remote controller address connector on the PCB from main to
sub position.
G The slide switch setting at the time of factory shipment for
model KH type is "A", and for model KHS type is "B."
G
KH(S)3072 / 3672R, KHH(S)2672R
RC
(WL)
G
KH(S)2672R
Page 84
Wired remote controller
When using
wrired
A
remote
controller
When using
wireless
B
remote
controller
When using
wired
A
remote
controller
When using
wireless
B
remote
controller
84
Remote controller
address connector
Main
RCU check
Sub
RCU. ADR
Nos. 1, 2 OFF, No. 3 ON
Nos. 1, 2, 3 all OFF
Nos. 1, 2 OFF, No. 3 ON.
Nos. 1, 2, 3 all OFF