Preparation For Embroidering And Monogramming - AEG 30Z Instruction Manual

Instruction manual for Model AEG 30Z /AEG 35Z
Free motion darning, embroidery and
monogramming
Stitch Length
0
Stitch Width
3.5~5
* Embroider hoop is not included with the
- Install the darning plate, see page 45.
- Remove the presser foot and the presser
- Draw the desired lettering or design on
- Stretch the fabric between the
- Place the fabric under the needle. Make
- Turn the balance wheel towards you to
- Hold the hoop with thumb and
Keep fingers away from moving parts,
especially needles.
46
Preparation for embroidering
and
monogramming
machine.
foot holder.
the right side of the fabric.
embroidery hoop as firmly as possible.
sure the presser foot bar is down to its
lowest position.
bring up the lower thread through the
fabric. Sew a few securing stitches at the
starting point.
forefinger of both hands while pressing
the material with the middle and third
finger and supporting the outside of the
hoop with your small finger.
Caution: