Cisco TelePresence Touch 10 Installation Manual page 2

FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
--Reorient or relocate the receiving antenna.
--Increase the separation between the equipment and receiver.
--Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
FCC Statement
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Caution!
Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
CanadaStatement
This device complies with IndustryCanada licence-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
On our web site you can find an overview of the worldwide Cisco contacts.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
Go to: http://www.cisco.com/web/siteassets/contacts
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
Corporate Headquarters
The device meets the exemption from the routine evaluation limits in section 2.5 of RSS 102 and compliance with RSS-102 RF exposure, users can
Cisco Systems, Inc.
obtain Canadian information on RF exposure and compliance.
170 West Tasman Dr.
Le dispositif rencontre l'exemption des limites courantes d'évaluation dans la section 2.5 de RSS 102 et la conformité à l'exposition de RSS-102 rf,
San Jose, CA 95134 USA
utilisateurs peut obtenir l'information canadienne sur l'exposition et la conformité de rf.
Cisco and the Cisco logo are trademarks or registered trademarks of Cisco and/or its affiliates in the U.S.
and other countries. To view a list ofCiscotrademarks, go to this URL: www.cisco.com/go/trademarks. Third-
party trademarks mentioned are the property of their respective owners.The use of the word partner does
not imply a partnership relationship between Cisco and any other company. (1110R)
China RoHS Hazardous Substance Table
Where to find additional support and information
for your Cisco TelePresence product
User documentation
For more information about Cisco TelePresence Touch 10 see the user documentation that
is available on our web site:
http://www.cisco.com/en/US/products/ps11336/tsd_products_support_series_home.html
Support
For support, go to: http://www.cisco.com/support
Note
This Table is a regulatory document required for products shipped to the People's
Republic of China.
Cisco TelePresence Touch 10
InStALLAtIOn gUIde
Call, share and control
video meetings with a touch of a finger.
78-100157-01 | SEPTEMBER 2013.
Copyright © 2013 Cisco Systems, Inc. All rights reserved.