Solenoid P; Gear Shaft Plate - Brother HL-600 Service Manual

3.12

Solenoid P

(1) Pull out the solenoid P from the frame by releasing the hook of the solenoid lever.
3.13

Gear Shaft Plate

(1) Remove the seven screws securing the gear shaft plate.
M4 screw
NOTE: On re-assembly, run the registration sensor harness along the route shown in the figure
below.
Registration sensor harness
Solenoid lever
Solenoid P
Fig. 3.14
Fig. 3.15
Gear shaft plate
Paper eject sensor harness
Main motor harness
III - 9