Philips CE600BT Quick Start Manual

Quick start guide

Register your product and get support at
www.philips.com/support
2017 © Gibson Innovations Limited. All rights reserved.
This product has been manufactured by, and is
sold under the responsibility of Gibson Innovations
Ltd.,and Gibson Innovations Ltd. is the warrantor in
relation to this product
Philips and the Philips Shield Emblem are registered
trademarks of Koninklijke Philips N.V. and are used
under license.
CE600BT_12_QSG_SafetySheet_V2.0
Always there to help you
Register your product and get support at
www.philips.com/support
Question?
Contact
Philips
Quick start guide
Safety
Read and understand all instructions before you use the device. If
damage is caused by failure to follow instructions, the warranty does
not apply.
The device is designed for negative ground (earth) 12 V DC
•
operation only.
• Risk of car accidents! Never watch video or operate this system
while driving.
• To ensure safe driving, adjust the volume to a safe and
comfortable level.
• Improper fuses can cause damage or fire. When you need to
change the fuse, consult a professional.
• Use only the supplied mounting hardware for a safe and secure
installation.
• To avoid short circuits, do not expose the device, remote control
or remote control batteries to rain or water.
The device shall not be exposed to dripping or splashing.
•
• Do not place any sources of danger on the device (e.g. liquid
filled objects, lighted candles).
• Never insert objects into the ventilation slots or other openings
on the device.
Risk of damage to the screen! Never touch, push, rub or strike
•
the screen with any object.
Clean the device with soft, damp cloth. Never use substances
•
such as alcohol, chemicals or household cleaners on the device.
• Always install this system in the car dashboard. Other locations
can be dangerous as the rear of the system heats up during use.
• To avoid short-circuit: before you connect, make sure that the
ignition is off.
• Make sure that you connect the yellow and red power supply
leads after all other leads are connected.
• Make sure that all loose leads are insulated with electrical tape.
• Make sure that the leads do not get caught under screws iron
parts that will move (e.g. seat rail).
• Make sure that all ground (earth) leads are run to a common
ground (earth) point.
• Use only the supplied mounting hardware for a safe and secure
installation.
• When you connect other devices to this system, make sure that
the rating of the car circuit is higher than the total fuse value of
all the connected devices.
• Never connect speaker wires to the metal body or chassis of the car.
Never connect speaker wires with stripes to one another.
•
Compliance
This product complies with the requirement of the 1999/5/EC directive.
Declaration of conformity
Hereby, Gibson Innovations declares that this product is in
compliance with the essential requirements and other relevant
provisions of Directive 1999/5/EC. You can find the Declaration of
Conformity on www.p4c.philips.com.
Care of the environment
Environmental information
All unnecessary packaging has been omitted. We have tried to make
the packaging easy to separate into three materials: cardboard (box),
polystyrene foam (buffer) and polyethylene (bags, protective foam sheet.)
Your system consists of materials which can be recycled and reused
if disassembled by a specialized company. Please observe the local
regulations regarding the disposal of packaging materials, and old
equipment.
Disposal of your old product
Your product is designed and manufactured with high quality
materials and components, which can be recycled and reused.
This symbol on a product means that the product is covered by
European Directive 2012/19/EU. Inform yourself about the local
separate collection system for electrical and electronic products.
Follow local rules and never dispose of the product with normal
household waste. Correct disposal of old products helps prevent
negative consequences for the environment and human health.
Trademark notice
The Bluetooth® word mark and logos are registered
trademarks owned by Bluetooth SIG, Inc. and any use
of such marks by Gibson Innovations Limited is under license. Other
trademarks and trade names are those of their respective owners.
Windows Media and the Windows logo are trademarks,
or registered trademarks of Microsoft Corporation in the
United States and/or other countries.
Copyright
2017 © Gibson Innovations Limited. All rights reserved.
Philips and the Philips Shield Emblem are registered trademarks of
Koninklijke Philips N.V. and are used under license.
Specifications are subject to change without notice. Gibson
Innovations reserves the right to change products at any time
without being obliged to adjust earlier supplies accordingly.

Product information

Power
• Power supply: 12 V DC (11 V - 16 V), negative ground
Fuse: 15 A
•
Display
• Type: LCD Touch-sensitive screen
Diagonal screen size (inch): 6.8
•
• Resolution: WVGA
Sound
Suitable speaker impedance: 4 - 8
•
• Maximum power output: 50 W x 4 channels
Continuous power output: 22 W x 4 channels (4
• 10% T.H.D.)
• Pre-Amp output voltage: 2.0 V
• Sub-woofer output voltage: 2.0 V
• Aux-in level: 800 mV
Connectivity
• USB
- USB2.0 or USB1.1
Bluetooth
•
- Profiles: A2DP, AVRCP 1.5, HFP, HSP
- Version: 3.0
- Range: 8 m (free space)
AV-IN
•
• Video output: Composite video out
• Preamp output
Sub-woofer output
•
• Parking camera
Radio
Frequency range - FM: 87.5 - 108.0 MHz (50 kHz per step)
•
• Frequency range - AM(MW): 522 - 1620 kHz (9 kHz per step)
USB
Output for power charging: 1 A
•
• File format: FAT16, FAT32
- Directory nesting up to a maximum of 8 levels
- Number of albums/folders: maximum 99
- Number of tracks/titles: maximum 999
- File name in Unicode UTF8 (maximum length: 128 bytes)
• Supported formats
- Video:
AVI (video codec: MP4V/ Xvid MPEG-1, audio codec: WMA/
PCM/LPCM MPEG-Audio (MP1/MP2/MP3));
MPG (video codec: MPEG-1/MPEG-2, audio codec: LPCM,
MPEG-Audio (MP1/MP2/MP3));
DAT (video codec: MPEG-1/MPEG-2, audio codec: LPCM,
MPEG-Audio (MP1/MP2/MP3));
FLV (video codec: H.263, audio codec: LPCM/MP3));
MP4/MOV (video codec: Xvid, MP4V; audio codec: WMA/
LPCM, MPEG-Audio (MP1/MP2/MP3), uLaw/aLaw));
Resolution: 720 X 480/576(30fps)
- Audio:
MP3 (Bit rate: 16 kbps - 320 kbps; Sampling rate: 8 K - 48 KHz);
WMA (WMA7, WMA8, WMA9 (only CBR, VBR), Bit rate: 16 kbps
- 320 kbps; Sampling rate: 8 K - 48 KHz);
ID3 tag v2.0 or later
- Picture: JPEG, BMP