Accessories - RIDGID JP06101 Operator's Manual

MAINTENANCE
CUTTER KNIFE SHARPENING
See Figure 48.
The knives can be honed individually with an ordinary oilstone.
NOTE: Make sure your oilstone is not worn in the center. It
must be flat.
Be sure to remove the burr on the flat side.
WARNING:
The cutter knives are extremely sharp. Do not
let your hand or fingers touch the cutter knives.
Failure to heed this warning could result in serious
personal injury.
If the knives are nicked they must be replaced or reground.
They can be reground several times until they become
9/16 in. wide. Never install unbalanced knives or reground
knives less than 9/16 in. wide.
Have your knives reground by someone who is competent.
Look under "Sharpening Services" in the Yellow Pages of
your telephone directory.
NOTE: The knives may have a second, very small ground
surface very close to the sharpened edge of the knife. Hone
only the edge of the knife which will be doing the cutting.

ACCESSORIES

Look for these accessories at The Home Depot:
Jointer Knives .............................................................................................................................................................AC8600
Push Blocks ...............................................................................................................................................................AC8601
Dust Collection Kit ......................................................................................................................................................AC8602
WARNING:
Attachments and accessories available for use with this tool are listed above. Do not use any attachments or
accessories not recommended by the manufacturer of this tool. The use of attachments or accessories not
recommended can result in serious personal injury.
11/16 IN.
WIDE
CUTTING
EDGE
31
38°
NEW KNIFE
SECOND
GROUND
SURFACE
Fig. 48