Checking Status Led - NEC EXP320R Maintenance Manual

Chapter 1 Maintenance
2.3

Checking STATUS LED

Check LEDs located at front of the server for any abnormalities after the server is powered on or before shutting
down the server and the server is powered off. Check LEDs for any abnormalities also while the server is
running.
Check LED indication when:

Power on the server and while the server is running.

Before shutting down the server.
LEDs to be checked:

LEDs located at front of the server

LEDs on hard disk drives installed in 2.5-inch hard disk drive bay
DISK ACCESS LED
If the indicator shows the server abnormality, contact your salses representative.
For the functions and descriptions of the LED, refer to Chapter 1 (6.1 Error Messages by LED Indication).
Express5800/R320e-E4, R320e-M4, R320f-E4, R320f-M4 Maintenance Guide (VMware)
20
Slot 1 Slot 3
Slot 0 Slot 2 Slot 4
Slot 0 Slot 2 Slot 4
Slot 1 Slot 3
System POWER LED
Slot 5 Slot 7
Slot 6
Slot 6
Slot 5 Slot 7
2. Daily Maintenance
System FAULT LED
System FT LED