Honeywell Galaxy Printer Interface Installation Manual

Galaxy Printer Interface

Installation Guide

The Galaxy Printer Interface allows connection of the full range of Galaxy
control panels to a serial printer with a suitable RS232 port.
The Printer Interface can be connected anywhere along the AB (RS585) data
Line 1. The serial printer set up requirements are as follows. For information
on setting up printer parameters please refer to the printer user guide.
RS232
Serial Printer
0v (Green)
TXD (Blue)
CTS (Red)
Baud Rate
Start Bits
Data Bits
Stop Bits
Parity
Printer columns
Table 1: Printer Settings.
RS232 RS485
GALAXY
PRINTER I/F
Figure 1: Galaxy Printer Interface Connection
Red-12v
Black-0v
Yellow-A line
Blue-B line
A134 (6-way DIN)
1200
1
8
1
None
40
AB Line 1 (RS485)
There are two models of Printer
Interface available:
Part number A134 is fitted with a
six way DIN plug.
Part number A161 is fitted with a
25-way Sub-D type connector.
Both are fitted with a four way IDC
socket for connection to the AB data 1.
The wiring connections for both Printer
Interfaces are as follows:
A161 (25-way DIN)
Pin 5
Pin 3
Pin 2
Galaxy
Control Panel
Pin 7
Pin 3
Pin 20