Set System Contact; Set System Location - Yamaha L2 Command Reference Manual

52 | Command Reference | Maintenance and operation functions
[Initial value]
no snmp-server enable trap
[Input mode]
global configuration mode
[Description]
Specifies the type of trap notification that is sent.
If this command is executed with the "no" syntax, traps are disabled.
[Example]
Enable coldstart trap.
SWR2311P(config)#snmp-server enable trap coldstart
Disable traps.
SWR2311P(config)#no snmp-server enable trap

4.10.3 Set system contact

[Syntax]
snmp-server contact contact
no snmp-server contact
[Parameter]
contact
[Initial value]
no snmp-server contact
[Input mode]
global configuration mode
[Description]
Sets the MIB variable sysContact.
sysContact is a variable that is typically used to enter the name of the administrator or contact.
If this command is executed with the "no" syntax, the setting is deleted.
[Example]
Set the system contact to "swr2311padmin@sample.com".
SWR2311P(config)#snmp-server contact swr2311padmin@sample.com

4.10.4 Set system location

[Syntax]
snmp-server location location
no snmp-server location
[Parameter]
location
[Initial value]
no snmp-server location
Setting value
rmon
termmonitor
: Name (maximum 255 characters) to register as the system contact
: Name to register as the system location (255 characters or less)
Description
When RMON event is executed
When terminal monitoring is detected