Show Class Map Information - Yamaha L2 Command Reference Manual

238 | Command Reference | Traffic control
[Parameter]
id-start
id-end
[Input mode]
class map mode
[Description]
Uses the VLAN ID as the condition to classify the traffic class.
To delete the classification condition, use the no match vlan command.
This can be used in conjunction with the setting of the match vlan command.
The match vlan command or match vlan-range command settings can be repeated up to the maximum number that can be
registered (30).
[Note]
In order to execute this command, QoS must be enabled.
[Example]
Specify VLAN #20 through #30 as the classification conditions for class map "class1".
SWR2311P(config)#class-map class1
SWR2311P(config-cmap)#match vlan-range 20 to 30

9.2.20 Show class map information

[Syntax]
show class-map [name]
[Parameter]
name
[Input mode]
unprivileged EXEC mode, priviledged EXEC mode
[Description]
Shows information for the specified class map. The following information is shown for each class map.
Section
Classification conditions (match)
• The classification condition is shown only once for each type that is specified.
• A classification condition for which a corresponding command (match) is not set will not be shown.
[Note]
In order to execute this command, QoS must be enabled.
[Example]
Show information for class map "class1".
SWR2311P#show class-map class1
: <1 - 4094>
Starting VLAN ID value used as classification condition.
: <1 - 4094>
Ending VLAN ID value used as classification condition. The range from the specified starting value
to the ending value can be a maximum of 30.
: Class map name. If this is omitted, all class map information is shown.
Item
Match Access-List
Match ethertype
Match vlan
Match vlan-range
Match CoS
Match IP precedence
Match IP DSCP
Description
Access list ID
Ethernet Type
VLAN ID
CoS value
TOS precedence
DSCP value