Digital Clock Setting Procedure - Hitachi EX1900-5 Operator's Manual

3. Station Presetting Procedure
(1) Select the desired station using tuning switches (5).
(Refer to the "Tuning Procedure" section.)
(2) Press and hold one station preset (4) for more than
2 seconds until an electronic tone is heard. Now,
the selected station is preset for the selected sta-
tion preset. The frequency of the preset station will
be indicated on digital display (7).
Once the presetting is complete for a station preset (4),
the radio will be tuned to the preset station when station
preset (4) is pressed (for less than 2 seconds).

DIGITAL CLOCK SETTING PROCEDURE

NOTE: In order to set the clock, digital display (7) must
be in the time display mode.
1. Press and hold display mode change switch (6).
While holding display mode change switch (6), use
time set switch (8) and/or set switch (9) to set the
clock.
The functions of time set switch (8) and set switch (9)
are as follows:
•
Time Set Switch (H): Each time set switch (H) is
pressed, the hour display will increase by one.
•
Time Set Switch (M): Each time set switch (M) is
pressed, the minute display will increase by one.
(The time is displayed in 12 hour standard.)
If either of the switches (H) or (M) is pressed and held,
the hour or minute display will change continuously un-
til the switch is released.
•
Set Switch (SET) (9): If set switch (SET) (9) is
pressed, the minute display will be reset to "00".
• If the minute display is "29" or smaller when set
switch (SET) (9) is pressed, the display will be reset
to "00" without changing the hour display.
• If the minute display is "30" or larger when set switch
(SET) (9) is pressed, the hour display will be in-
creased by one and the minute display will be reset
to "00".
For example, if the set switch (SET) (9) is pressed
when the clock display is "10:29" and "10:30", the
clock display will change to "10:00" and "11:00" re-
spectively.
OPERATOR'S STATION
1-40
7
4
7 6
8 9
5
M157-01-027
M157-01-027