Table of Contents
Advertisement
Getting started
Switching on or off the phone
1. Open the phone, if necessary.
2. Press and hold
for more than one second to
switch on the phone.
The service light flashes and then the idle
screen appears on the display as soon as the
system locates service.
If the phone is out of a service area, the No
Service icon (
) appears on the display. In
this case, you cannot place and receive calls.
Try again later when service is available.
Note: You can change the display language in the
Language/
menu (
page 53.
3. When you wish to switch off the phone, press
and hold
for more than 2 seconds.
WARNING!
Do not switch on the phone when mobile phone use
is prohibited or when it may cause interference or
danger.
Note: Do not touch the antenna on the phone
unnecessarily when the phone is switched on.
Contact with the antenna affects the call
quality and may cause the phone to operate at
a higher power level than otherwise needed.
22
-OK-6). See
Your phone's modes
Standby mode
Standby mode is your phone's basic state. The
phone goes into Standby mode soon after you turn
it on, or whenever you briefly press
phone is in Standby mode, you will typically see the
current time and date. If you enter a phone
number, you can press
to dial it, or press
save it in Phonebook.
Press
at any time to return to Standby mode. Be
careful; if you are on a call when you press
your phone disconnects the call and returns to
Standby mode.
Talk mode
You can place and answer calls only when your
phone is turned on. During a call, the phone is in
Talk mode. While you are in Talk mode, pressing
gives you a list of options. See page 36 for
details.
Power save mode
Your phone comes with a Power Save feature that is
automatically activated if your phone is unable to
find a signal after 15 minutes of searching. While
this feature is active, the phone's battery charge is
conserved. To return to Standby mode, press any
key.
Getting started
. When your
to
,
23
Advertisement
Table of Contents
