Table of Contents
Advertisement
en
14 | ��� | KT400 system settings
6.1.4
Touch calibration
When feeling the screen distorted during the use, the
user may need to calibrate the touch screen. Click the
Touch Calibration module to enter into the calibration
window.
Operation steps:
1. Click "Touch calibration" button, Click on the center
of cross cursor accurately with the touch pen by
following the prompt.,One calibration ends once the
cursor changes;
2. Cross cursor will move to 5 points, include top left
corner, below left corner, top right corner, below
right corner, and center, after completing calibration
at all corners, the system will prompt it the screen
has been calibrated successfully and will return to
the system setting menu automatically.
i
Don't click on the srceen before the cursor appears,
otherwise it may lead to calibration failure.
6.1.5
�ontrast adjustment
This function menu allows you to adjust LCD bright-
ness of the instrument. Owing to its characteristics,
LCD may perform differently in different sunlight, at
different temperature and humidity. You may adjust and
save the brightness value of LCD at any time to achieve
the best effect.
Operation steps:
1. By clicking the buttons "-" and "+" increase or decre-
ase the brightness percentage;
2. After adjustment, click "ok" button, save the adjust-
ments; You can click "cancel" button, don't change
the adjustments.
6.1.6
Time and date setting
This function is used to set time and date, for example:
when you screenshot, the file name include current
date and time.
Operation steps:
1. Please select the change items;
2. By clicking the buttons "-" and "+" adjust the date
and time;
3. Select format and separator of date; select time
zone and format of time;
4. Click "OK" button, save the adjustments; you can
click "Cancel" button, don't change the adjustments.
6.1.7
�ehicle Logo Replacement
There are two vehicle logo replacement methods: single
replacement and integral replacement, with the single
replacement taken as the default mode. The picture
size is 136*115 (mm) and the picture format is bmp.
6.1.7.1 Single Replacement
Only one vehicle logo can be replaced one time.
Operation Steps:
1. Select "Single Replacement";
2. Select the vehicle logo to be replaced in the left
dropdown box;
3. Select the target vehicle logo on the right;
4. Click the
button in the middle to synchronize
logos at both sides; at the same time, the replace-
ment button changes to the available status;
5. Click the "Replace" button.
i
You can select the vehicle logo according to brand
when single replacement.
6.1.7.2 �ntegral Replacement
Several vehicle logos can be replaced one time.
Operation Steps:
1. Select the "Integral Replacement";
2. Click the "Browse" button to select the target pic-
ture folder, and its path shall correspond with the
path in the CF folder;
3. Click the "Replace" button.
6.2
Network Setting
6.2.1
Network connection
This function is used to set netword connection.
Automatic access to IP or automatic access to DNS,
click "OK" button to save the setting informaton.
Operation steps of manually set the IP:
1. Click "Manually set the IP" option;
2. Order to enter information of IP adress, Subnet mask
, the default gateway;
3. Click "OK" button to save the information.
Operation steps of manually set the DNS:
1. Click "Manully set the DNS" option;
2. Order to enter information of "Preferred DNS server"
or "Altemate DNS server";
3. Click "OK" button to save the information.
Bosch Automotive Diagnostics Equipment (Shenzhen) Limited
Advertisement
Table of Contents
