C
To
(+) terminal
(Red)
D
E
Wire-end Ferrules
Battery DC cable
15 mm
To
(-) terminal
(Black)
(A)
Insert the battery DC cables into the cap of
the cable gland and insert the cables into two
holes of the rubber itting one by one.
NOTE
y For DC cables of battery connections, the
cross-sectional area of lead wire between
2
2
2.5 mm
and 4 mm
is recommended.
y The maximum cable diameter for the cable
gland is 4 mm. (including sheath)
Insert the battery DC cables through the
battery DC cable gland.
NOTE
When inserting cables into the product, make
sure not to damage internal components.
Strip the battery DC cables and assemble wire-
end ferrules on each wire.
1. Strip a DC cable about 15 mm length and
insert a wire-end ferrule into the cable.
2. Crimp the ferrule end using wire-end ferrule
crimping tool (A).
NOTE
Cables and wire-end ferrules are not supplied
on this product package. The system
installer is responsible for selecting proper
components for the installation such as
cables and wire-end ferrules.
Installation
21
2