ABB PST30 Installation And Maintenance Manual page 63

Pst series; pstb series
Hide thumbs Also See for PST30:
Table of Contents

Advertisement

Made in Sweden
Key-Pad
PTC
Fieldbus
Figure 1: Principle of a fieldbus network with PST softstarters connected
8
8.2
1SXU 132 021 M0201
Chapter 8
Fieldbus communication (option)
8:1 Overview
The PST softstarter has an interface on the front for connecting the ABB fieldbus plug is
used for fieldbus communication. Through this interface, it is possible to control the soft-
starter, achieve status information, as well as upload and down-load parameters.
The interface between the softstarter and the eplug is always the same. Independent of
softstarter size, it is possible to connect any fieldbus protocol in the future since the protocol
is defined in the eplug itself.
The following fieldbus protocols are available:
• AS-Interface
• DeviceNet
• Profibus DP
• Modbus
8:1.1 Required accessories
To connect the softstarter to a fieldbus system, the following accessories are required:
• Fieldbusplug for appropriate protocol (check that the cable length is sufficient).
• Connectors for bus connection.
• End plug (some protocols).
• Software for PLC set-up.
8:1.2 Instructions
To set up I/O, parameters, etc., please visit www.abb-control.com, go to the Literature
Made in Sweden
Library, select "3. Technical Manual Download Library" and scroll down the page to
Key-Pad
PTC
Fieldbus
locate the Softstarter technical literature library. Engineering document packages can be
downloaded for all available protocols.
Low Voltage Products & Systems
ABB Inc. • 888-385-1221 • www.abb-control.com

Advertisement

Table of Contents
loading

Table of Contents