Hitachi AMS2100 User Manual page 175

1. On the host where CCI is installed, verify that CCI is not running.
If CCI is running, shut it down using the horcmshutdown
command.
2. In the command prompt, make two copies of the sample file
(horcm.conf). For example:
•
c:\HORCM\etc> copy \HORCM\etc\horcm.conf \WINDOWS\horcm0.conf
c:\HORCM\etc> copy \HORCM\etc\horcm.conf \WINDOWS\horcm1.conf
3. Open horcm0.conf using the text editor.
4. In the HORCM_MON section, set the necessary parameters.
Important: A value more than or equal to 6000 must be set for
poll(10ms). Specifying the value incorrectly may cause resource
contention in the internal process, resulting in the process
temporarily suspending and pausing the internal processing of
the array. See the Hitachi Adaptable Modular Storage Command
Control Interface (CCI) User's Guide for more information.
5. In the HORCM_CMD section, specify the physical drive
(command device) on the array. For example:
•
Figure C-1: Horcm0.conf Example (P-VOL; S-VOL=1: 3)
Operations using CCI
Hitachi AMS 2000 Family Copy-on-Write SnapShot User Guide
C-5